Want this question answered?
Add the coolant into the coolant reservoir. Be sure the engine is cool when you remove the cap off the reservoir.
Remove the coolant reservoir, flush it out, reinstall it and refill with proper coolant.
Coolant is added via the expansion/reservoir tank. Remove the cap when engine is cool and add coolant to the full line.
Remove the reservoir bolts and nut. Disconnect the motor electrical connector. Detatch the fluid hose from the reservoir Take the reservoir out.
Drain the coolant, remove the alternator and the etc. sensor hose from the reservoir. Remove the housing and replace the thermostat.
Then you need to "accidentally" remove it ... pronto, which may mean flushing out the entire coolant system if the engine has been run.
The battery on a 1995 Chevy Lumina 3100 is located on the right side of the car underneath the engine coolant reservoir. To change the battery, you have to take off safety bar, remove engine coolant reservoir, then undo the battery restraints. Washer fluid reservoir is on right, over battery. Coolant reservoir is on left. There is a hold down piece at bottom of battery, will need an extension to reach it.
To check the coolant level of a vehicle first see look for the overflow reservoir. There should be a coolant dipstick with a level gauge on it. Remove it from the reservoir to see the coolant level.
there is a 10 mm bolt right underneath the coolant reservoir an a clip securing it down in the back remove both of those and it will come out
cold engine only remove the radiator cap and pour then fill to cold line on the reservoir
Locate the radiator and the coolant reservoir box. Remove the lid of the coolant reservoir. Then remove the drain plug from the bottom of the radiator. When the fluid has leaked out, put the plug in place. Pour in a mixture of distilled water and antifreeze into the reservoir, according to your needs or the specifications. Run the engine for three minutes, then check the coolant level and add more if needed. Be careful not to remove the hose from the reservoir as the plastic nipple it is fastened to will easily break if too much force is used.
It is located between the top front of the engine & the radiator. You have to remove the front rack & plastic shroud to access.