answersLogoWhite

0

This is an awesome post for how to replace the dash lights; it also shows you how to take the dash cover/cowel off by lifting straight up until the pins come out:

http://www.ionforums.net/viewtopic.php?t=444

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace tail lights in a 2005 Mercedes SLK?

open the trunk, remove the plastic cover assy, remove the required bulb, 1/2 turn and replace same. Replace plastic cover, by pushing the plastic rivits stright in.


How do you change the dashboard lights on 2005 crown vic?

you have to remove the cover of the dashboard to replace the light bulbs


How do you replace a rear brake light on a Nissan primera?

To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.


How do you replace light in gear shift 2004 Saturn Vue?

To replace the light in the gear shift of a 2004 Saturn Vue, first, you need to remove the center console cover. Carefully pry off the cover using a flathead screwdriver or trim tool to avoid damaging the plastic clips. Once the cover is removed, locate the burned-out bulb, twist it counterclockwise to remove it, and replace it with a new bulb. Finally, reassemble the console cover by snapping it back into place.


How do you replace rear tail light lens?

Pull back trunk cover inside trunk. Remove the large thumb screws inside the trunk. There will be 6-10. Remove lens assembly from outside. Unplug all lights from lens. Install lights in new lens a replace in car. Reinstall thunb screws and tighten. Replace trunk cover


How do you change tail lights on a 3000gt?

remove the back plastic cover in the hatch and youll see the back of the bulb, unscrew and replace.


How to replace interior lights fuse in 1992 Toyota Paseo?

To replace the interior lights fuse in a 1992 Toyota Paseo, first locate the fuse box, which is typically found under the dashboard on the driver's side. Remove the fuse box cover and identify the specific fuse for the interior lights, usually labeled in the diagram on the cover. Use a fuse puller or pliers to carefully remove the faulty fuse. Replace it with a new fuse of the same amperage, then reassemble the fuse box cover and test the interior lights to ensure they are working properly.


How do you replace crankshaft seal on Saturn sl1 1.9 liter?

remove belts,remove crank pulley,remove seal.you need to check front cover they are bad about timing chain rubing holes through it.


How do you replace the dashboard lights on 1997 F-150?

check your door switches (little push switch the door hits when closed)and the headlight switch could be gumed up.I have a 95 f 250 and it was the headlight switch.picked one up at the salvage yard for 5.00 I have a 98 F150 that was doing the same thing I sprayed wd40 over where the door switch was and after closing it a couple of times the light stayed off. No problems since


How do you remove the cover from the third brake light that is mounted at the top of the hatch to replace the bulb?

The bulbs in the middle on my 94 Saturn went out one a time, you don't have to remove a cover, they are accessible by lifting the trunk lid. There are like 5 of them they just pop in and out.


How do you replace the dash lights on a 1992 miata?

To replace the dash lights on a 1992 Miata, start by removing the dashboard cover by unscrewing the necessary screws and gently prying it off. Once the cover is removed, locate the gauge cluster and unscrew it to access the light bulbs. Carefully twist and remove the old bulbs and replace them with new ones, ensuring they are properly seated. Reassemble the gauge cluster and dashboard cover, and test the lights to ensure they work.


How do you remove the rear lamp cover on a Nissan Xterra to replace the brake light?

access to the rear brake lights is inside the vehicle. Open the rear hatch and on the rear corners of the vehicle, you will see a small cover plate. Take the cover plate off and this will give you access to the lights.