answersLogoWhite

0

Actually, you do not need to remove the dash faceplate. The center bezel just snaps off. It is best to start around the lower part, near the read wiper/defroster switches. There are four snaps, two on each side.

Answerthere are 4 screws, Phillips that is, that 2 are above the odometer and one is at the headlight pull switch and other is at the stogie lighter. that's all there is, and pull up and out. easy.
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change the oil pump in a 2000 Jeep Cherokee Sport 4.0?

Remove the oil pan and you will see the oil pump. Simply replace it.


How do you replace the choke 1994 Jeep Cherokee Sport?

doesn't have a choke , but has an enrichener valve , remove the bolts that hold the valve ,take it out unplug & replace ,can be found near throttle body .


Where is the timing belt on 2001 Cherokee sport and how easy is it to replace?

The timing belt is not a belt on a Cherokee sport. It's a chain. It's located under a housing on the crank shaft. In order to replace it you will need to remove the alternator, the water pump, the a/c compressor, the radiator and the engine fans. An experienced mechanic can get it done in about 3 to 6 hours.


How much to replace a water pump on a 2000 jeep sport Cherokee?

$100000


What does it cost to replace the oil pump on a 2001 Jeep Cherokee Sport?

The cost to replace the oil pump on a 2001 Jeep Cherokee Sport ranges from $300 and $500. Replacing the oil pump requires the oil pan to be removed.


How much does it cost replace an exhaust system on Cherokee sport?

just paid 500


How can i fix the fuel filter on a 99 Jeep Cherokee sport?

You do not fix it you just replace it.


How do you replace slave cylinder 1992 Jeep Cherokee sport?

To replace the slave cylinder on a 1992 Jeep Cherokee Sport, first, safely lift the vehicle and remove the transmission access cover. Disconnect the hydraulic line from the slave cylinder and remove the mounting bolts to take out the old cylinder. Install the new slave cylinder, ensuring it is properly aligned, then reconnect the hydraulic line and bleed the clutch system to remove any air. Finally, reassemble the access cover and lower the vehicle.


Can you remove the cross bar on your 2001 Jeep Cherokee Sport?

The 2001 Jeep Cherokee crossbar is welded to the frame of the vehicle. You will need to use a cutting torch to remove the crossbar.


Do i have to replace front bumper to attach winch on 1997 Cherokee sport?

With most winch kits, yes.


How do you replace the automatic window motor and regulator for the drivers side window on a 1994 Jeep Cherokee Sport?

Remove the door panel. Remove the bolt that fastens the regulator to the window. Remove the 3 bolts that hold the regulator assembly to the door. Squeeze the entire assembly through the largest hole and replace with a new assembly in reverse order.


1995 Cherokee sport - where is petcock located?

It is near the right front headlight. You have to remove the grill to access.