To replace the slave cylinder on a 1992 Jeep Cherokee Sport, first, safely lift the vehicle and remove the transmission access cover. Disconnect the hydraulic line from the slave cylinder and remove the mounting bolts to take out the old cylinder. Install the new slave cylinder, ensuring it is properly aligned, then reconnect the hydraulic line and bleed the clutch system to remove any air. Finally, reassemble the access cover and lower the vehicle.
How does the belt for fan and water pump go on a 2000 Jeep Cherokee Sport 6 Cylinder?
If you get underneath the jeep you can easily see, if the lines go directly into the bellhousing, then its internal, my jeep has an internal
Chain
The clutch master cylinder is in your engine compartment , the hydraulic clutch slave cylinder is inside your manual transmission bell housing
The 2.4 L - 4 cylinder Vin1 (DOHC) Jeep engine has a belt and it is an interferance engine. Replace belt at 120,000 miles.
$100000
The cost to replace the oil pump on a 2001 Jeep Cherokee Sport ranges from $300 and $500. Replacing the oil pump requires the oil pan to be removed.
It will bolt in, but the intake on the 1996 is different and the cylinder head on the 1996 does not have the temp sensor for the gauge in the same location.
just paid 500
You do not fix it you just replace it.
4 cylinder holds 5 quarts 6 cylinder holds 6 quarts.
the rear is usually smaller and closer to the brake booster