To remove the front brakes on a 1989 Oldsmobile Delta 88, start by loosening the lug nuts on the front wheels and lifting the vehicle securely on jack stands. Remove the wheel, then take off the caliper by unscrewing the caliper bolts; support it with a hanger to avoid stress on the brake line. Next, remove the brake pads and the caliper bracket if necessary, then take off the rotor by pulling it straight off the hub. Remember to check for any additional components that may need to be removed based on your specific brake system configuration.
The firing order for a 1989 Oldsmobile Delta 88 3.8L V6 is: 1-6-5-4-3-2 The #1 cylinder is located in the RIGHT FRONT.
3.8 liter, v-6 front wheel drive.
remove the large bolts between the door and the vehicle....
Iota Delta was created in 1989.
Delta Dreamflight was created in 1989.
I have a Delta 88 and its located about 18 inches in front of the rear tire on the driver side, its right under the second door of the driver side.
The Crankshaft sensor is located behind the Harmonic Balancer on the front-passenger side
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
you need to remove the entire steering knuckle and have a machine shop press out the hub and bearing for you.
I have a P205/75R14