they are just held in by a clip so you should just be able to pop them up and out so that you can take out the old speakers
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
You don't need to remove front door panels, the speaker grills come out.
The speakers are under the grills near the outer edge of the dash cover. To get the speaker grills out simply pry up on them with a thin blade screw driver. Be careful to avoid deforming the dash cover. The speakers are held in with screws, take them out and pull up on the speaker, release and remove the wire connectors.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
To remove a magnet in a speaker, first detach the grill in the front of the speaker, second unscrew the speaker after that remove the speaker from the cabinet and cut the speaker cone. Lastly, gently discard the magnet from the speaker cone.
there are two options one speaker grill in front door = 4" X 6" oval two speaker grills in front door = 5 1/4" round this is as per crutchfield audios website.
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
1) Fold down the back seats 2) Remove (4) 10mm bolts retaining the seat frame to the body 3) Route the rear seat seat belts through the slit towards the bottom on each side 4) Undo the (3) christmas-tree fasteners on the front of the rear-deck panel 5) Carefully remove the rear deck panel 6) Undo the three fasteners on the underside of the speaker grills, and remove.
The 1992 Chevy Corvette front speaker covers are held in place with two retaining screws. Remove the retaining screws and the speaker covers will come off.
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
Remove the speaker covers, by loosening the retaining screws. Remove the speaker retaining screws. Remove the wiring harness. The speakers will come out.
You have to remove the whole dashboard and then the speaker should be exposed, then just remove it.