0
To remove the ignition lock on a 2001 Ford Windstar, first disconnect the negative battery cable to prevent electrical shorts. Then, remove the steering column covers by unscrewing the screws holding them in place. Insert the key and turn it to the "run" position, then locate the ignition lock cylinder release pin, which is typically found on the underside of the steering column. Press the release pin with a small tool while pulling out the ignition lock cylinder.
What else can I help you with?
How do you remove 2001 ford windstar drivers seat cusion?
Machete.
How do you remove ignition lock key without key?
Removing a ignition lock cylinder from a 2002 ford windstar with no key
Does the 2001 ford windstar have a distributor cap?
No , the 3.8 liter V6 engine in a 2001 Ford Windstar has the Electronic Distributorless Ignition System ( EDIS ) It has ( 1 ) coil pack that has ( 6 towers with 6 spark plug wires )
Remove the inside door panel on 2001 ford windstar?
I would advise against it.
Does a 99 side mirror on a Ford Windstar fit a 2001 Windstar?
Yes. The mirror on the 2001 Ford Windstar is the same mirror found on the 1999 Ford Windstar. They are interchangeable.
Why does your ignition stick on a 98 Ford windstar?
because its a ford
Do you have a 3.8 engine for a 2001 Windstar Ford Van?
Do you have a 3.8 engine for a 2001 Windstar Ford Van?
Lost your only key to a Ford Windstar 2001 - how can you get replacements?
Ford Dealership should be able to help. If not you may have to replace the ignition and steering column .$$$.
How much horsepower does a 2001 ford windstar have?
The 2001 Windstar is rated at 200hp
Does the 2001 ford windstar have a timing belt or chain?
The 2001 3.8L Ford Windstar has a timing chain, not a belt.
2001 ford windstar 3.8 liter ignition wire routing?
A haynes manual will have that. Find at your local auto parts store.
How do you clean 2001 Ford Windstar carbureator?
There is no carburetor on a 2001 Ford Windstar engine because the engine is fuel injected
