0
It doesn't matter. Your key won't work in the new one. They have to do something at the shop to make it work.
Actually you can remove it without the shop needing to do anything. My wife had an issue with ers, the dealer wanted to charge 200$ to fix it. I took it out, took it apart, cleaned it and reinstalled it and now it works fine. Its all over the internet how to do it.
actually your key will work in the new one... you require a 15 torx angled to remove the old ignition switch and the replace it in the same order in which removed... after that put the key in the ignition and turn as if you were going to start it and then the pass-lock sensor will come on the dash at this time its programming the pass-lock system for your key and after ten minutes go by then the pass-lock symbol will turn off and then turn the ignition as if you start again and then it will do the same thing 10 mins and then off and turn the ignition and wait another 10 minutes turn the key and it should start. and everything will work again....
however the Saturn dealer if they do it all they have to do is program it threw your computer thus making it less time for them but it can be done and the only place you can buy the ignition switch is at the dealer not avail anywhere else...
and this is a known defect with the car although Saturn will never admit it or will they replace it at no cost...
What else can I help you with?
How to Remove ignition switch from Nissan?
how to change a ignition switch on a nissan altima 2003
How do you remove broken antenna on a 2003 Saturn ion?
how to remove and replace broken antenna on a 2003 Saturn ion
Car stereo installation for 2003 Saturn vue?
remove 2003 Saturn vue radio
How do you unlock the ignition switch on a 2003 dodge neon?
How do i unlock my ignition switch on 2003 dodge neon sometime it does it some times it doesn't but now it wouldn't unlock
How do you remove the ignition key cylinder from a 2003 Kia Optima when a key broke off in the cylinder?
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
What are the stages of failure on an ignition switch on a 2003 Chevrolet Malibu?
remove trim around switch ( it just pops off ) then remove the hold down bolts, push in at an angle a bit then pull it out. but unhook battery negative cable first ! then remove the connector for the wires.
How do you remove ignition switch on a 2003 Saturn ion?
check out the following web site: http://www.saturnfans.com/forums/showthread.php?t=92569 if the link does not work, search the saturnfans.com website for the link. We just replaced one and are hoping it works. We are in the timing-cycle phase of the replacement as I type this.
Does a 2003 Saturn Ion have chip key ignition?
No, not any of the Saturn ION's manufactured by GM have chip keys, regardless of the model year.
Where can you get an ignition switch dash cover for a 2003 Monte Carlo?
You can get the ignition switch dash cover for the 2003 Monte Carlo at places like Auto Zone. You can also find this item online at AutoSport Catalog or on Ebay.
Does a 2003 Toyota Highlander have a ignition cut off?
It is controlled by the ignition switch. Other than that I am unfamiliar with what you might be referring to.
How do you get the key out of the ignition of your 2003 Land Rover?
To remove the key from the ignition of a 2003 Land Rover, ensure that the vehicle is in the "Park" position. Turn the ignition switch to the "Off" position, and gently pull the key out. If the key won't come out, check that the steering wheel isn't locked; sometimes, turning the wheel slightly can release the ignition lock. If issues persist, there may be an underlying problem with the ignition system that needs professional attention.
How do you remove a hazard light switch in a 2003 impala?
lollolol
