To remove the instrument panel in a 2000 Chevy Tracker, start by disconnecting the negative battery cable to prevent electrical issues. Next, remove any trim pieces surrounding the panel, typically held by screws or clips. Unscrew the instrument panel mounting screws, carefully disconnect any electrical connectors, and then gently pull the panel out. Be sure to handle it carefully to avoid damaging any components.
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
The trim panel should be held on with screws around the edge. The instrument panel under that should be held in with screws also. Unhook the speedometer and the wires plugged into it.
A mystery to me. Don't want to break anything but cannot figure out the fasteners.
To change a light bulb in the instrument panel cluster of your 1988 Chevy G20 van, first disconnect the battery to ensure safety. Remove the dashboard cover by unscrewing any screws or clips, then carefully pull out the instrument panel. Locate the burnt-out bulb, twist it counterclockwise to remove it, and replace it with a new bulb. Reassemble the instrument panel and dashboard cover, then reconnect the battery.
on the dash under directional
Are you asking about the trim panel above the glove box or the trim panel in front of the radio or the trim panel around the instrument cluster? Ask again telling us which panel you wish to remove.
It is a length process that requires the removal of many screws.
two camels in a tiny car
Remove the screws in the door panel.
The fuse is identified as "SRS" (Supplemental Restraint System) and is located in the Driver's Side Instrument Panel Fuse Box. To access it, open driver's door & remove the Cover on the side of the Instrument Panel...
You need to remove the dash in order to get back there to replace any blown bulbs.