answersLogoWhite

0

You'll need to first remove the door panel, then unplug the connector from the back of the switch panel. If you want to replace the panel, you simply push the entire panel towards the top of the door and it will pop out of the snap retainers. If you have power side view mirrors, you may want to unplug that connector as well as the speaker connector for ease of handling.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you remove the rear power windows on a 1991 Chrysler LeBaron convertible?

You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job


How do you replace the window switch on a 1993 325i?

Remove the decorative cover to the window switch panel. Remove the window switch retaining screws. Remove the wiring harness from the back of the window switch. Reverse the process to install the new window switch.


How much is a 1992 Chrysler Lebaron convertible top?

On eBay there about $160 to $200 dependiing on if you need the rear window. You'll have to remove back seats to get at the complete convertible frame. The tops will come with instructions. Its a lot of work and very time consuming plan for a whole weekend.


How do you lower the top on a 1991 Lebaron convertible?

Unlatch the latches at the top of the window, then press the convertible top button down. this button is located near the armrest. If this does not work you must aquire a new convertible top motor. from the trunk, remove hyd. fluid from the conv. top pump, operate top by hand. worked for me for years


Is a right rear window motor the same on a 1990 Chrysler Lebaron convertible as a 1990 Chrysler Lebaron hard top?

no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..


In a 1991 lebaron convertible can the plastic window be replaced by a glass window?

Yes! If you have a zipout window. It will require top half open. Then the lower panel removal, re-stapling of the new meterial to the panel. Good luck tight fit.


How do you change the left rear power window motor assembly on a 1995 Chrysler Lebaron LX convertible?

I was just searching the list and there is an answer to a similar question already in FAQ


How do you change the window regulator on a 1998 Pontiac Sunfire Convertible?

To change the window regulator on a 1998 Pontiac Sunfire Convertible, first, remove the door panel by unscrewing the screws and gently prying it off. Disconnect the window switch harness and any other connected components. Next, remove the old regulator by unbolting it from the door and carefully taking it out, then install the new regulator by following the same steps in reverse. Finally, reattach the door panel and test the window operation.


How do i replace a sonata power window switch?

Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.


Is the rear quarter window mechanism the same in the Chrysler lebaron coupe and the convertible?

Knowing the way Chrysler often interchanges parts from many different cars, I would assume it would be about the same.


Is there a difference between the right or left rear window motor on a Lebaron convertible?

No. The the same part number is applicable for both driver and passenger side windows. Front and rear are also the same.


Will a 1991 windshield for a lebaron fit a 1988 lebaron?

yes, it should theyre mostly the same in those years Yes, it fits! Even the windshield from the coupé fits in the convertible and the one from the convertible fits to the coupé. As they are glued, they are not easy to bring out without crack, take care, U use a good tool for this. On the LeBarons newer than 1992, the Mirrors are not glued to the window anymore