You have to remove the back seats.. and then the panels.. windows are held in by 10mm bolts.. disconnect the connectors at the bottom if the window unit.. Allow an hour to do this.. PIA job
Show removel of trunk lock 1993 chrysler lebaron
Inside of the car. Remove the glove box.
Counter clock wise to loosen.
remove back up tire in back right behind seat
To remove the rear seat back in a 1992 Chrysler LeBaron Convertible, first, locate the retaining bolts at the bottom of the seat back; these are usually accessible from the trunk. Use a socket wrench to remove the bolts. Once the bolts are removed, gently pull the seat back upward and away from the seat base to detach it. Be cautious of any clips or connectors that may also need to be released.
Remove door panel where switch is located. Remove itch. Use fine emery board nd clean points. It worked for me
To change the transmission filter on a 1995 Chrysler LeBaron convertible, start by draining the transmission fluid by removing the transmission pan. Once the pan is off, you'll see the filter; unbolt and remove it. Replace it with a new filter, ensuring any gaskets or seals are properly positioned. Reattach the pan, refill the transmission with fluid, and check for leaks.
To remove the back seat of a 1989 Chrysler LeBaron convertible, first, locate and remove the seat bottom by pulling up on the front edge to release it from the clips. Next, for the seat back, look for bolts or screws at the base or sides that secure it; remove these using the appropriate tool. Once detached, gently lift the seat back upwards to release it from any remaining clips or hooks. Be sure to check for any seatbelt attachments that may need to be disconnected before completely removing the seat.
Need more info - which engine? 2.2/2.5? By 1989 no LeBaron had a carb.
The convertible top relay for a 1989 Chrysler LeBaron is typically located in the relay box under the dashboard on the driver's side. You may need to remove the cover to access the relays. It's often labeled, so check the diagram on the cover or in the owner's manual for identification. If you're having trouble finding it, consulting a repair manual specific to the vehicle model can also help.
On eBay there about $160 to $200 dependiing on if you need the rear window. You'll have to remove back seats to get at the complete convertible frame. The tops will come with instructions. Its a lot of work and very time consuming plan for a whole weekend.
To change the rear brakes on a 1992 Chrysler LeBaron convertible, first, lift the rear of the vehicle and secure it on jack stands. Remove the wheel and then the brake caliper by unbolting it, allowing it to hang (do not disconnect the brake line). Replace the brake pads and, if necessary, the rotors, then reassemble by reversing the disassembly steps. Finally, pump the brake pedal to ensure proper brake function before lowering the vehicle.