To change the rear brakes on a 1992 Chrysler LeBaron convertible, first, lift the rear of the vehicle and secure it on jack stands. Remove the wheel and then the brake caliper by unbolting it, allowing it to hang (do not disconnect the brake line). Replace the brake pads and, if necessary, the rotors, then reassemble by reversing the disassembly steps. Finally, pump the brake pedal to ensure proper brake function before lowering the vehicle.
They went from the hide-a-way lights to the molded lens in 1993.
To change the transmission filter on a 1995 Chrysler LeBaron convertible, start by draining the transmission fluid by removing the transmission pan. Once the pan is off, you'll see the filter; unbolt and remove it. Replace it with a new filter, ensuring any gaskets or seals are properly positioned. Reattach the pan, refill the transmission with fluid, and check for leaks.
I was just searching the list and there is an answer to a similar question already in FAQ
If its anything like my 88 lebaron convertible on the inside your going to have to take out the trim on the floor by the door and then take off the whole side panel in the back seat...a pain!
The first step on how to change the motor on a 1992 Chrysler LeBaron V6 3.0l is to position the vehicle to where you can get the hoist in and out.
You pull the old one out and push a new one in.
13/16 inch
If same engine and transmission model, yes.
The best thing to do for a repair quetion like this one is to go to your local NAPA or Kragen, or whatever the local parts house is, and get a Haynes repair manual for your vehicle. If you have any questions just ask the clerk to help you.
engine needs to be removed
Anything is possible. It was never offered as a convertible, so it will be all custom work.
13/1613/16