answersLogoWhite

0

I'm assuming that you mean the Harmonic Balancer on the Crankshaft?? If so, You have to use a Chain Wrench to hold the pulley from turning while you loosen the bolt. Wrap Duct Tape around the pulley to not damage the pulley with the chain. Once you remove the bolt, use at least a 5 or 6 inch gear puller. Remember to put the bolt back in a few turns so you have a resting place for the center bolt of the gear puller. Caution: Don't allow the pulley to turn CCW at any time.

Removing the radiator makes life much easier for this job.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

I have 1995 4x4 Geo Tracker with a bad auto transmission will auto transmission out of 1998 4x4 Geo Tracker fit in 1995 Geo Tracker?

i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995


Will a fivespeed trans out of a 1990 Geo Tracker fit a 1995 Geo Tracker?

Yes it should.


Timing marks 1996 geo tracker 1.6l 16 valve?

The 1996 Geo Tracker 1.6 liter engine timing marks can be found on the outside of the main pulley. The timing marks will be scattered around the pulley.


How do you get sterio out of a 1995 Geo Tracker?

get a bigger hammer


Will a 88-94 Geo Tracker Soft top fit a 1995 Model?

yes a,90-99,willfit a geo tracker.


Have to replace water pump on a 95 Geo tracker had to remove the radiator to get at the fan bolts and remove fan and fancover do you also have to pull the pulley to remove the timing cover?

just remove the water pump not the timing cover


What is the coolant capacity of a 1995 Geo Tracker?

5.3 Quarts


How do you remove crankshaft pully on a 2004 Geo Tracker?

To remove the crankshaft pulley on a 2004 Geo Tracker, first ensure the engine is off and cool, then disconnect the negative battery terminal. Use a socket and ratchet to remove the bolt securing the pulley, but you may need to use a crankshaft pulley holder tool to prevent the engine from turning. Once the bolt is removed, gently pull the pulley off the crankshaft, taking care not to damage any surrounding components. If it's stubborn, a puller tool may be necessary to assist in removing it.


What Tire Sizes are Available for a 1995 Geo Tracker?

195/75R15


Did 95 Geo Tracker have driver side airbag?

No airbags in the 1995.


Where is the crank shaft position sensor on a 1995 Geo Tracker?

in the distributor


Is a 1995 geo tracker automatic transmission electronic shift?

yes