answersLogoWhite

0

1. Jack the vehicle up 2. Remove nuts holding "y" exhaust pipe 3. lower exhaust 4. remove starter bolts(2) and wiring, but only after battery is disconnected 5. Starter will wiggle out of it's position

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace a starter on a 1988 Chevy astro van?

Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


How do you replace starter on 1988 Chevy 1500 pickup?

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


IS A 1987 CHEVY TRUCK DOOR INTERCHANGEABLE WITH A 1988 K5 BLAZER?

Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988


Where is the solenoid starter on a 1988 Chevy s10 blazer?

It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.


How do you Replace starter in 1988 Corvette?

You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.


How do you replace the starter on a 1988 Chevy pickup 8 cylinder?

Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter


Will a 2.8 engine from a 1988 Chevy beretta fit a 1989 Chevy blazer?

Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...


How do you adjust the choke on a 1988 Chevy s 10 blazer?

There is no choke to adjust.


What do you have to do to remove a starter for a 1988 Chevy Cheyenne 6-cylinder standard trans?

you must remove the clutch slave cylinder and line. Then unbolt the starser and install the new one


How do you set timing on a 1988 Chevy blazer s10 v6?

I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.


How do you change the starter on a 1988 Chevy Caprice Classic?

Disconnect the Caprices battery. Remove the wires from the starter, then unbolt the unit. Pull the starter out, then put the new one in the hole. Bolt up the new starter, connect the wiring, then reconnect the battery.


Where is the starter found on a 1988 Chevy Celebrity?

The starter is on the bottom of the block on the side nearest the radiator.