0
you first remove the engine mounting brackets, then you place a jack under the transmission and remove the cross member bolts that hold the transmission up. after the bolts are removed you can lower the transmission down which will tilt the motor back allowing access to the top 2 bolts from the back side
What else can I help you with?
How do you change front shocks on Toyota pickup 2wd?
Remove 3 bolts, remove shock, insert shock, compress shock, replace bolts
Where are the starter mounting bolts on a 94 Toyota 4x4 pickup?
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
How do you separate the bell housing from the transmission on a 1996 S10?
The 1996 Chevy S 10 pickup truck bell housing is held in place with eight retaining bolts. Remove the retaining bolts and the bell housing will separate from the transmission.
How do you remove the starter from a 1998 Toyota 4runner 4 cylinder?
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
How do you replace the thermostat in a 1996 Toyota Camry?
remove the bolts holding the housing connected to the top radiator hose. go from there
How do you remove the 4 wheel drive hub on 1988 Toyota pickup?
remove the bolts around the outside of the hub. pull it off. then remove the next set of bolts to remove the inner hub. there may be a snap ring to remove the inner hub as well.
How do you remove the top bolts on a Toyota pickup transmission?
a really long extension works really good if you took the transfer case off allready.
What are the Torque specs for 1995 Toyota thermostat housing?
The 1995 Toyota Tacoma thermostat housing torque specification is 40 pounds. The amount of torque on the thermostat housing bolts is not that important. You basically do not want to break the thermostat housing bolts.
How do you remove the front bumper on a 1989 Toyota 4x4 pickup?
The front bumper bolts directly to the factory mounts on the frame. You need to remove four bolts, two on each side. Use a 14 mm socket wrench. The bolts are parallel to the ground and perpendicular to the center of the vehicle.
How do you remove you joint on Toyota pick up?
To remove the joint on a Toyota pickup, first, safely lift and secure the vehicle. Then, disconnect the battery and remove the wheel for better access. Use a socket or wrench to detach the bolts securing the joint, and if applicable, gently tap with a hammer to loosen it. Finally, carefully pull the joint from its housing, ensuring to check for any additional retaining clips or components that may need to be removed.
How do you remove the rear cup holder on a 1998 Corolla LE?
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
How do you replace a master cylinder on a 1993 Toyota Pickup?
remove brake lines, remove bolts on the bracket that holds the cylinder to the brake booster then its free. Some cases you will have to pry open the brake shoes.
