answersLogoWhite

0

a really long extension works really good if you took the transfer case off allready.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the top two bell housing bolts on a 1991 Toyota pickup?

you first remove the engine mounting brackets, then you place a jack under the transmission and remove the cross member bolts that hold the transmission up. after the bolts are removed you can lower the transmission down which will tilt the motor back allowing access to the top 2 bolts from the back side


How do you change front shocks on Toyota pickup 2wd?

Remove 3 bolts, remove shock, insert shock, compress shock, replace bolts


Where are the starter mounting bolts on a 94 Toyota 4x4 pickup?

The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.


How do you remove the starter on a 1996 Toyota T100 4x4 pickup?

To remove the starter on a 1996 Toyota T100 4x4 pickup, first disconnect the negative battery cable to ensure safety. Then, locate the starter under the vehicle, typically near the transmission. Remove the bolts securing the starter to the engine, and disconnect the electrical connections, including the main power cable and the solenoid wire. Once all connections are free and the bolts are removed, the starter can be taken out from its mounting position.


How do you remove the 4 wheel drive hub on 1988 Toyota pickup?

remove the bolts around the outside of the hub. pull it off. then remove the next set of bolts to remove the inner hub. there may be a snap ring to remove the inner hub as well.


How do you remove the starter from a 1998 Toyota 4runner 4 cylinder?

The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.


Does drive shaft need to be removed to install clutch in Toyota pickup?

Yes because you have to take the bolts out of the transmission and slide back enough to replace your clutch.


How do you remove the rear oil pan bolts on a 2001 Toyota Tacoma?

I believe you remove the transmission dust shield via the 4 bolts that hold it one. once removed, you should have plenty of room to access the rear bolts.


How do you separate the bell housing from the transmission on a 1996 S10?

The 1996 Chevy S 10 pickup truck bell housing is held in place with eight retaining bolts. Remove the retaining bolts and the bell housing will separate from the transmission.


How do you remove the front bumper on a 1989 Toyota 4x4 pickup?

The front bumper bolts directly to the factory mounts on the frame. You need to remove four bolts, two on each side. Use a 14 mm socket wrench. The bolts are parallel to the ground and perpendicular to the center of the vehicle.


How do you replace a master cylinder on a 1993 Toyota Pickup?

remove brake lines, remove bolts on the bracket that holds the cylinder to the brake booster then its free. Some cases you will have to pry open the brake shoes.


What is the torque specs for head bolts on 87 Toyota pickup 4 cylinder 22re?

Torque as follows 53-63 ft/lbs. in 3 steps