0
The fan bolts to the front of the water pump using 4 bolts (13 mm head). first u have to remove the upper and lower fan shroud. This will grant you access to remove the fan assembly and provide elbow room to remove the water pump after you get the fan out of the way. it usually take 1-2 hours to replace this water pump. be sure to cool the engine first and drain all the antifreeze into a container. there are approximately 5 bolts, give or take, that hod the water pump to the engine block. Count the holes in your new pump to be sure you have removed them all before you try to pry the old pump from the block. Some of these bolts are different length so i like to put them in the new pump as i pull them out of the old one so i know which one goes where.
P.S. dont forget to remove the radiator hose from the pump first.
THE FAN IS SCREWED ON NO BOLTS,USE A LARGE WRENCH AND A SPEICAL TOOL TO HOLD THE PULLEY
What else can I help you with?
How do you change thermostat in a 1972 Chevy Chevelle?
# Drain the radiator below the thermostat level # Remove the water outlet elbow assembly from the engine and the remove the thermostat
How do you remove the fan clutch from a 2001 Chevy Tahoe?
I used two large wrenches,but my water pump assembly was out of the vehicle at the time
Water pump leak 2005 Chevy Silverado?
Very helpful!
How do you replace a water pump on a 1997 5.7 liter Chevy Silverado pickup?
remove upper fan shroud, unbolt fan from water pump, remove belt, remove hoses from water pump, remove water pump bolts, transfer heater hose fitting to new waterpump, clean up old gasket, install in reverse order.
What is the water sound coming from behind dash in 2000 Chevy silverado?
you now get over it
How do you replace water pump on 2003 5.3L Chevy Silverado Z71?
look in the manual
Where is the water pump on 2003 Chevy silverado?
On a 2003 Chevy Silverado, the water pump is typically located at the front of the engine, mounted to the engine block. It is driven by the serpentine belt and is usually positioned on the driver's side. To access it, you'll need to remove the serpentine belt and may need to take off other components, such as the fan or radiator shroud, depending on the specific engine configuration.
Where the water pump on 2002 Chevy silverado 3500?
That is what the big fan on the front of your engine is bolted to.
Where is the EGR valve located on a 1996 Chevy Silverado?
It is in the middle between the intake and the water pump.
Where is the water pump located on 1994 Chevy Silverado?
That is what the fan is bolted to that's on the front of your engine.
How much does it cost to replace a water pump in a 2002 Chevy silverado?
3 to 4 hundred dollars
Why does your 99 Chevy silverado ext cab leak water on the passenger side?
maybe the heater core.
