You have to pull the transmission. then it's just 3 bolts/nuts through flywheel.
how to drai torque converter on 1999 chevy blazer
You need to remove the lower transmission inspection cover.
big job you have to remove trans or at least back it out enough to remove torque converter cause its behind it
what are the torque specks for 85 Chevy s10 with a 2.5 engine
No drain plug. Filter is located inside the transmission pan on the bottom of the tranny.
The front seal on your automatic transmission would be between the torque converter and the front pump of the transmission. The transmission would have to be removed along with the torque converter to replace the seal.
Which engine is in it ? First disconnect battery remove torque converter cover if it is an auto trans remove starter bolts position so you can remove rest of wires stand starter vertical rotate and let it com out the bottom
To remove the TCC (Torque Converter Clutch) solenoid on a Chevy S10, first, disconnect the vehicle's battery to prevent any electrical issues. Then, locate the solenoid, which is typically found on the transmission. Remove the electrical connector and any mounting bolts securing the solenoid in place. Finally, pull the solenoid out, making sure to replace any seals if necessary during reinstallation.
33 ft lbs of torque
It is between the torque converter and the front pump of the transmission. The transmission or engine has to be removed to gain access to the front transmission seal.
The catalytic converter is found in the exhaust system between the engine and the muffler.
It is located in the catalytic converter