Transmissions and Drivetrains
Chevy S-10
Chevy Blazer S-10

How do you change the front automatic transmission seal on a 1987 Chevy S10 Blazer with a 28 v6?

212223

Top Answer
User Avatar
Wiki User
2007-01-22 05:58:33
2007-01-22 05:58:33

big job you have to remove trans or at least back it out enough to remove torque converter cause its behind it

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Located inside the transmission Check auto zone.com repair section

User Avatar

The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.

User Avatar

There are many bolts that assemble a transmission, automatic or standard. Be more specific.

User Avatar

The 1996 Chevrolet blazer transmission control system helps the transmission to maximize optimal fuel consumption. The control system keeps the transmission in the overdrive gear.

User Avatar

There are several seals in that transmission, need to know which one.

User Avatar

can I put a 99 Chevy 4l60e transmission in my 86 k5 chevy blazer

User Avatar

On the driver's side of the transmission (range select cable is attached to it).

User Avatar

Yes, they both had the same transmission options.

User Avatar

You will have to remove the transmission pan that is on the bottom of the transmission to drain the fluid.

User Avatar

where can i buy a transmission dip stick for a 1995 chevy blazer

User Avatar

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck

User Avatar

Assuming you have an automatic transmission the dipstick is located under the hood on the passenger side in back of the engine, close to the firewall.

User Avatar

They are bolted to the valve body, Have to remove transmission pan to service them.

User Avatar

Automatic transmission, on the left side (drivers side) of the transmission. Standard transmission, on the clutch peddle assembly.

User Avatar

NO it will not. They are complete DIFFERENT designs. Will NOT interchange.

User Avatar

Yes it is. It will go right in there with no problems. Will not have to change anything.

User Avatar

you have to pull the transmission out-- or the enging which either is easier

User Avatar

the linkage to the transmmison probably needs to be adjusted


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.