0
To remove the transaxle from a Pontiac Montana, start by disconnecting the battery and then removing any components that obstruct access, such as the air intake, exhaust, and drive axles. Support the engine with a hoist, then unbolt the transaxle from the engine and lower it carefully. Finally, detach any remaining electrical connections, fluid lines, and the transmission mount before sliding the transaxle out from under the vehicle. Always consult a repair manual for specific torque specs and procedures.
What else can I help you with?
What size wrench is needed to remove front axle nut on 2001 Pontiac Montana?
34mm for 2001 non-AWD
How do you remove front axle from a Pontiac grand prix?
Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.
Is it required to break the transmission loose from the engine to drop the oil pan on a 4.7L 2002 Dodge Ram 1500 engine?
Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.
What size socket do you need for the axle nut on a 200 Pontiac Montana?
34 mm
How do you replace the flywheel in a Pontiac Bonneville?
The most common way is to support the engine from above, drop the frame under the engine and trans-axle, remove the transmission and clutch. Replace flywheel and reassemble.
Where is the air compressor for the auto level system in a 2000 Pontiac Montana?
Left rear quarter near the axle.
Where is the transmission dipstick in a 2001 Pontiac Sunfire?
Pontiac does not make a transmission dipstick, unless the newer ones have them. Actually, the early models did. My '96 had one. Later models did not. The trans fluid is checked via a plug in the side of the trans-axle.
Where do you find the dipstick to your transmission fluid for your 1994 Acura Integra?
The" manual" trans axle check/fill plug is located on the passenger side of the trans axle. use a box end wrench to remove it.
How do you remove left drive axle on a 97 Camry?
remove axle hub nut and tie rod to spindle connection. remove sway bar connection to control arm if present. pry/pound/press axle from hub, be careful not to damage threads on axle. Axle should hang loose at this point. Look for any bolts holding axle to trans, but should not be present on this car. Pry on inner part of axle between trans and axle end. Pry hard enough and it will pop out. Pound axle back in from outer end, be careful not to damage the axle and get splines lined up
What makes tires turn?
the axle or trans-axle
How do you remove the half shaft from the trans-axle on a 2004 Acura RSX?
Don't waste your time taking out the half shaft. Take the few bolts that are holding the rest of the axle and remove the half shaft with the other part of the axle all together. Its a hundred times easier. That's what we did in my 05 RSX type S. when we pulled the trans. out of the car.
How do you change the front axle on a 1998 Honda civic?
jack up car remove wheel remove axle nut take bottom 19mm bolt loose and 14mm loose from horseshoe remove horseshoe separate spindle from lower ''a'' arm pull Axle out of spindle remove from trans to replace reverse process
