To repair the heater hose on a Chrysler Cirrus, first, ensure the engine is cool and disconnect the battery. Locate the damaged heater hose, then use a hose clamp to secure a new section of hose if the damage is minor, or replace the entire hose if needed. Cut the old hose off, attach the new hose to the fittings, and secure it with new clamps. Finally, refill the cooling system with coolant and check for leaks.
The Cirrus did not have the 2.7L. On the 2.7L it is under the housing where the lower radiator hose hooks to the engine.
The Chrysler Cirrus was only built from 1995-2000. The radiator cap is located on the housing where the upper radiator hose hooks to the engine.
repair manuals i dont have a repair manual I have a manual, but it doesn't answer the question either.
Look below where the upper radiator hose hooks to the engine.
4 cylinder : under upper radiator hose fitting on engine.6 cylinder : under the housing that lower hose hooks to.
If the problem is the rear heater metal tubing coming from the engine and running down the bulkhead toward the rear of vehicle you can replace with oem at about 149.00 for the line or you can remove the line and cut out the bad section replacing it with heater hose, protecting it from heat and zip tieing it away from exhaust. You can also use copper tubbing instead of hose.
Should be at the bottom or rear of radiator or remove the lower radiator hose
In the thermostat housing on the engine. It is under the housing where the lower radiator hose hooks to the engine.
be more specific.. replace pads..?? replace hose..?? repair master cylinder..??
On the four cylinder it is under the housing where the upper radiator hose hooks to the engine. On the six cylinder it is under the housing where the lower radiator hose hooks to the engine.
repair the heater hose.
It is under the housing where the lower radiator hose hooks to the engine.