You can use any sheet metal, it must be undercoated, ,and should be at least 8guage, also must be welded with a torch not a mig welder, good luck
Replace water pump for an 1986 Chevy Nova?
R12
In 1963, Chevrolet produced approximately 20,000 units of the Nova model, but the convertible version was quite rare. Specifically, only about 5,000 convertible Chevy Novas were made that year. This limited production makes the 1963 Nova convertible a sought-after classic among collectors today.
It unscrews.
The Chevrolet Nova had a production run of more than 2.3 million vehicles. The Chevrolet Nova model was introduced in 1963.
My 64, with small block, and automatic was just under 2700.
No, a 1965 Nova hood will not fit a 1963 Nova due to differences in dimensions and design. The 1963 and 1965 models have distinct body styles and hood configurations that make them incompatible. If you're looking to replace or modify your 1963 Nova's hood, it's best to find a hood specifically designed for that model year.
To replace the steering column on a 1963 Chevy II Nova, first disconnect the battery to ensure safety. Remove the steering wheel by unscrewing the retaining nut and using a steering wheel puller if necessary. Next, detach any electrical connections, the ignition switch, and the mounting bolts holding the column in place. Finally, reverse the process to install the new column, ensuring all connections are secure before reconnecting the battery.
I believe it was the 64 Chevy Nova
1962 - 1963 chevy II Nova Acadian posi or open
13 inch, 4 lug, and I think 5 inches wide.
more than likely the windshield is leaking and the water is running behind the dash onto the floor.