Turn Signal and Windshield Wiper Switch
Removal 1. Disconnect battery ground cable (14301).
2. Tilt column to lowest position and remove tilt steering column lock lever (3F527).
3. Remove ignition switch lock cylinder.
4. Remove shroud screws and remove upper steering column shroud and lower steering column shroud.
5. Remove two self-tapping screws retaining turn signal and windshield wiper switch to steering column tube casting. Disengage turn signal and windshield wiper switch from casting.
6. Disconnect two electrical connectors.
Installation 1. Install two electrical connectors to full engagement.
2. Align turn signal and windshield wiper switch mounting holes with corresponding holes in steering column tube casting. Install two self-tapping screws, making sure to start screws in the previously tapped holes. Tighten . 3. Install upper steering column shroud and lower steering column shroud.
4. Install ignition switch lock cylinder.
5. Install tilt steering column lock lever.
6. Connect battery ground cable.
7. Check steering column tube and turn signal and windshield wiper switch for proper operation.
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
How to change blinker switch in a 1994 Firebird ?
The 1994 Toyota Corolla signal flasher relay switch is located beneath the drivers side dashboard. The signal flasher relay switch will be above the accelerator pedal.
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
The signal switch is placed right below the steering wheel of the car. It has an adjustable knob that is commonly used for signaling.
how to relace a door jamb switch in a 1994 f150
http://www.ehow.com/how_5041038_change-signal-switch-chevy-blazer.html
nevermind
hook back the horn 1994 chevolet lumina
Huh?
There is a short in the switch. Replace it/.
another questionI have been looking for a turn signal switch and can't find one. To replace it you should just be able to take off the cover around thesteering column and snap it in where the old one was. I would be able Tobe more detailed if I could find a replacement.