0
To replace a CV joint on a 2003 GMC Sonoma, start by safely lifting the vehicle and removing the wheel. Then, detach the axle nut and any components obstructing access to the CV joint, such as the brake caliper and rotor. Remove the old CV joint from the axle shaft by pulling it off, and install the new CV joint by sliding it onto the axle. Finally, reassemble all components, ensuring everything is securely fastened before lowering the vehicle.
What else can I help you with?
Where is the IAT senor in a 2003 gmc sonoma?
where is the iat sensor located on a 2003 gmc sonoma truck
How do you replace turn signal switch on 2003 gmc sonoma?
In order to remove the turn signal from your 2003 GMC Sonoma, you would need to remove the lower dash cover and also the steering column cover. I have included a video below in the related links section that will show you exactly how to fix this.
How do you replace the headlight bulb located on a 2003 GMC Sonoma?
If its anything like my 04 sonoma, there should be two flat pins which hold the headlight assembly in place. the pins come out, the socket for the bulbs become acessible. twist out and replace. .
Where are the freeze plugs in a 1996 gmc sonoma?
Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?
What type of engine oil should be put into a 2003 GMC Sonoma?
I have a 95 Sonoma. I use 5W30.
What is the oil capacity of 2003 2.2 GMC Sonoma?
I am asking a qustion??
Where do you change the oil in a 2003 GMC sonoma ZR2?
In your garage or driveway!
How do you remove lower ball joint on 2003 GMC savana?
how to remove lower ball joint on 2003 gmc savana van
How much load can a 2003 gmc sonoma carry?
It is a half ton pickup ,correct?
Where is the low pressure port on a 2003 GMC Sonoma?
It's located right on the evaporator
How many mpg can you expect to get from a 2003 gmc somona?
Im getting 17.5mpg in my 2003 sonoma z-r2
How do you replace an upper ball joint on a 2002 sonoma?
To replace the upper ball joint on a 2002 GMC Sonoma, begin by safely lifting the vehicle and removing the front wheel. Disconnect the upper control arm from the ball joint by removing the retaining nut and using a ball joint separator to detach it. Once the old ball joint is removed from the control arm, install the new ball joint, secure it with the retaining nut, and reattach the control arm. Finally, reassemble all components, check for proper alignment, and lower the vehicle.
