0
To replace the upper ball joint on a 2002 GMC Sonoma, begin by safely lifting the vehicle and removing the front wheel. Disconnect the upper control arm from the ball joint by removing the retaining nut and using a ball joint separator to detach it. Once the old ball joint is removed from the control arm, install the new ball joint, secure it with the retaining nut, and reattach the control arm. Finally, reassemble all components, check for proper alignment, and lower the vehicle.
What else can I help you with?
How do you replace upper ball joint on 2002 sierra?
Part Of Upper Control Arm
How do you Replace upper threaded ball joint on 2002 dodge van?
To replace the upper threaded ball joint on a 2002 Dodge van, first lift the vehicle and remove the front wheel for access. Disconnect the upper control arm from the steering knuckle and any associated components, then unthread the old ball joint from the control arm using a ball joint removal tool. Install the new ball joint by threading it into the control arm, then reassemble by reconnecting the control arm to the steering knuckle and reinstalling the wheel. Finally, lower the vehicle and check for proper alignment.
2002 ford explorer upper balljoint replacement. do you have to replace the upper control arm or can you replace just the balljoint .?
You will need to replace the upper control arm. My research has determined it is not possible to purchase the ball joint seperately. If you do happen to find the ball joint you will have to press the old one out of the control arm which can be a real pain. Autozone has a tool to do it with but I am opting to just change the control arm so the bushing are also new. Moog Part number for the Upper Ball Joint is K80008. This is WITHOUT the control arm. Changing the control may prove to be easier but will most likely be a dealer item.
How do you replace the rear upper ball joint on a 2002 sebring?
You have to remove the rear tire and you will see the Rear ball joint pressure fit into a round bar the easiest way to get this out is to heat it with a blow torch and pound it with a hammer and chizzle. This should eventually pop it out and then the new one is much easier to replace.
How do you install new door pins and bushings on 2002 gmc Sonoma?
You replace the truck ...it comes with new hinge pins :((
How do you replace the thermostat on a 2002 Cavalier 22 Ecotec?
To replace the thermostat on a 2002 Cavalier 22 Ecotec, drain the radiator and remove the upper hose assembly. Replace the thermostat and refill the radiator.
What are the release dates for Adventure Highway - 2002 Sonoma California 1-3?
Adventure Highway - 2002 Sonoma California 1-3 was released on: USA: 2002
What are symptoms of a bad fuel pump on a 2002 GMC Sonoma 4.3 liters?
what are the symptoms of a bad fuel pump on a 2002 GMC Sonoma 4.3 liters?
Fuel Regulator location on 2002 GM sonoma 4 wheel drive 4.3 liter?
It is located under the upper intake manifold. It is attached to the "spider" (bank of injector poppets).
How much does it cost to replace a cv joint on a 2002 kia spectra?
the car is totaled
How do you replace a cv joint in a 2002 Chevy Trailblazer?
The boot on my cv joint is stuck inside of the trans how do u go about getting that out and what else do i need to fix after that comes out
Where are the grease zerks on an 2002 GMC Zr2 Sonoma?
One on each ball joint (4), one on each tie-rod end (4), two on the idler arm, one on the pitman arm,
