0
You have to remove the rear tire and you will see the Rear ball joint pressure fit into a round bar the easiest way to get this out is to heat it with a blow torch and pound it with a hammer and chizzle. This should eventually pop it out and then the new one is much easier to replace.
What else can I help you with?
How do you replace upper ball joint on 2002 sierra?
Part Of Upper Control Arm
How to replace push rods on a 2002 Chrysler sebring gtc?
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
How do you replace an upper ball joint on a 2002 sonoma?
To replace the upper ball joint on a 2002 GMC Sonoma, begin by safely lifting the vehicle and removing the front wheel. Disconnect the upper control arm from the ball joint by removing the retaining nut and using a ball joint separator to detach it. Once the old ball joint is removed from the control arm, install the new ball joint, secure it with the retaining nut, and reattach the control arm. Finally, reassemble all components, check for proper alignment, and lower the vehicle.
How do you Replace upper threaded ball joint on 2002 dodge van?
To replace the upper threaded ball joint on a 2002 Dodge van, first lift the vehicle and remove the front wheel for access. Disconnect the upper control arm from the steering knuckle and any associated components, then unthread the old ball joint from the control arm using a ball joint removal tool. Install the new ball joint by threading it into the control arm, then reassemble by reconnecting the control arm to the steering knuckle and reinstalling the wheel. Finally, lower the vehicle and check for proper alignment.
Where is the sensor for the radiator fan on a 2002 Chrysler Sebring?
It is near to where the upper radiator hose attaches to the engine.
Where is the thermostat on a 2002 Chrysler Sebring 2.4 liter?
It is under the housing where the upper radiator hose attaches to the engine.
How much does it Cost to replace a starter on a 2002 Chrysler Sebring?
Depends on where you get it done but was $365 for me. Yuck!
Ignition switch will not turn Replace?
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
2002 ford explorer upper balljoint replacement. do you have to replace the upper control arm or can you replace just the balljoint .?
You will need to replace the upper control arm. My research has determined it is not possible to purchase the ball joint seperately. If you do happen to find the ball joint you will have to press the old one out of the control arm which can be a real pain. Autozone has a tool to do it with but I am opting to just change the control arm so the bushing are also new. Moog Part number for the Upper Ball Joint is K80008. This is WITHOUT the control arm. Changing the control may prove to be easier but will most likely be a dealer item.
Can you replace a 2.7L engine in a 2002 Chrysler Sebring convertible with a 3.0L from a same year Chrysler Sebring coupe?
It is not a direct swap. They use different transmissions, computers, wiring, etc.
Where is the cabin filter on a 2002 Chrysler Sebring?
A 2002 Chrysler Sebring was not built with a cabin filter.
How do you replace a fuel pump on a 2002 Chrysler sebring?
you must drop the fuel tank, its held on by 2 straps(bolts)
