two screws on the side of the bed where the tailgate closes over have to be taken out. then you pull the whole light assembly out there are two pins in the light to hold it in they sould pull right out they will hold the light back at first and make it hard to pull but pull strait out so you dont break the pins.
Remove the ligth assy and unscrew it from the rear.
How do you replace a turn signal bulb in a 1998 cavalier
2009 Dodge Ram 1500 turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
how do i change driver side turn signal bulb on 1992 dodge caravan?
trouble putting right front signal bulb in.
2010 Dodge Ram 1500 turn signal light bulb lamp replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
How do you replace the side mirror turn signal bulb on a 2008 Passat?
tail/stop/turn signal bulb # 3057 park/turn signal bulb # 3157NA
How do you replace the front turn signal bulb located on a 2001 Buick Century?"
9004
You have to remove some screws and then pull the headlight assembly out of its place. it is held in with a clip after all the screws are removed.