2009 Dodge Ram 1500 turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
you will probably have to replace the complete mirror, cable and all.
96 dodge ram side rear view mirror will not stay in position
Take the door panel off of the door.Remove the three bolts that hold the side view mirror on.
Most common cause of the turn signals not flashing is a defective flasher relay. Replace it.
I took a fillet knife and ran it behind the mirror to cut the glue. Advance Auto sold the right replacement. Apply glue strips and press mirror on.
Got to take the door panel off to excess the bolts.
take the door panel off and their are 3 nuts you must remove and unplug the power supply going to the mirror
I have a 96 Dodge Ram with same mirror problem. Started after about 135k miles. Dealer said they just "wear out" and they need to be replaced. They are OK under 60 mph, but after that they both turn in. If I do replace, I will go with power mirrors to prevent future problems. you dont need to replace the mirror! take the cover off the mirror where it attaches to the door and the problem will be easy to see. But how do you remove the cover?
Depends what is wrong. On most of these you have to replace the entire part.
Inner door panel has to be pulled off or loose to get to the nuts that hold the mirror on, take the nuts off and if the mirror is power you have to disconnect the wires and then just pull the mirror off.
To reattach a side view mirror on a Dodge Stratus, first, ensure you have the correct replacement mirror and any necessary tools, such as a socket wrench or screwdriver. Remove any broken pieces of the old mirror and clean the area where it will be reattached. Align the new mirror with the mounting bracket and secure it in place using screws or bolts. Finally, reconnect any wiring for features like heating or turn signals, if applicable, and test the mirror for proper adjustment.
you can remove the old glass and simply silicon glue the glass replacement in. Cost of mirror is 10 to 12 dollars. Takes 15 minutes