To replace the distributor cap on a 1985 Oldsmobile Cutlass, first ensure the engine is off and disconnect the negative battery terminal. Remove the existing distributor cap by unscrewing any screws or releasing clips, then carefully note the position of the ignition wires for reassembly. Install the new distributor cap by aligning it with the distributor and securing it in place, then reconnect the ignition wires to their original positions. Finally, reconnect the battery and start the engine to verify proper installation.
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
First, remove the thermostat housing. Then grab the thermostat by hand and remove it.
The 1985 Oldsmobile Cutlass computer is located behind the passenger side dashboard. You will need to remove the glovebox in order to access the computer.
cutlass supremes are so baller
15"
If you have enough $, yes
Depends on which motor you're referring to
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
the firing order is 165432.
pulley puller
no they are not. Diferent design intirely.
library