answersLogoWhite

0

Pry out the old one and press in a new one (usually tap in with a hammer & seal driver or flat piece of metal

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the freeze plug 94 Nissan pick up?

where is the freeze plug 94 nissan pick up?


How do you replace distributor cap on 94 camaro z28 5.7liter?

What about the timming


Where is a freeze plug on a straight 6 from a 94 ford f150?

Up your but


Why would you have a coolant leak behind your timing cover 94 camaro 3.4 V6?

It could be a bad freeze plug, or the raditior or water pump maybe going bad. Take it to a repair shop. Not a good sign.


Where is fuel pump on 94 camaro?

in the gas tank. you have to remove the tank to replace the pump.


94 z28 Camaro?

What do you need to know about a 94 Z28 camaro?


How to inStall anti theft computer 94 Camaro?

hello ! were is the theft control module on my 94 camaro


Will a transmission from a 94 Camaro interchange with a 97 Camaro?

ya


Is your 94 camaro a rs or z28?

There was no RS Camaro in 1994.


Where is the freeze plug on a 94 ford ranger?

lots of freeze plugs along bottom side of engine block on rear of block behinf fly wheel on engine heads


How do you replace freeze plugs on 94 Lincoln town car?

To replace freeze plugs on a 1994 Lincoln Town Car, first, drain the engine coolant and remove any components obstructing access to the freeze plugs. Use a freeze plug removal tool or a hammer and a chisel to carefully remove the old plugs. Clean the area thoroughly, then apply a sealant if desired, and press in the new freeze plugs using a socket or a similar tool to ensure a snug fit. Finally, refill the coolant and check for leaks.


How do you replace freeze plugs in a 94 ford ranger?

To replace freeze plugs in a 1994 Ford Ranger, first drain the engine coolant and remove any components obstructing access to the freeze plugs. Use a freeze plug removal tool or a hammer and chisel to carefully remove the old plugs. Clean the areas where the new plugs will be installed, then insert the new freeze plugs using a socket or driver to ensure they are seated properly. Finally, refill the coolant and check for leaks after starting the engine.