0
What else can I help you with?
How do you change the distributor cap wires for a 1985 camaro?
get a set of new plug wires for it that are pre-cut for the car and then replace 1 wire at a time.
How do you replace a camshaft sensor on a 1999 Tahoe?
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
How do you install a 1996 camaro distributor cap?
undo the hold down screws and pull off, replace the rotor and install the new cap and then transfer plug wires one at a time to the proper location on the new cap.
Where on a 1989 Z 28 Camaro is the ignition module located?
under the distributor cap
How do you replace distributor cap for 1993 buick century?
it is distributorless no cap to replace has coil packs
Where is the distributor cap on a 95 camaro 6-cylinder 3.4 located?
According to about.com it doesn't have a distributor , it has 3 coil packs
How do you replace the distributor cap and rotor on a 1998 Toyota RAV4?
there is no distributor on a 98 rav. therefore no cap or rotor. replace the plugs and wires and the tuneup is done
What is the wiring diagram order on the distributor cap for a 1990 camaro v-8 engine?
18436572
Distributor cap removal for 97 Chevy cavalier 2.2L?
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
How do you replace the cap and rotor on your 1997 camaro z28?
Remove wires from old distributor and put on new one [one at a time, noting locations on distributor, or marking wires and locations]. Remove rotor [noting direction it is pointing] and replace with new one pointing in same direction].
How do you replace the distributor cap on s Mitsubishi diamante?
To replace the distributor cap on a Mitsubishi Diamante, first, ensure the engine is off and cool. Disconnect the negative battery terminal for safety. Remove the screws or clips holding the distributor cap in place, then carefully detach the cap from the distributor. Install the new cap by aligning it properly, securing it with screws or clips, and reconnecting the battery terminal.
How do you install distributor cap if the screws are bad?
Replace the screws.
