To replace the front hub assembly on a 2002 Chevy Tracker, first, elevate the vehicle and remove the front wheel. Then, disconnect the brake caliper and rotor, followed by removing the axle nut and any bolts securing the hub assembly. Once these components are detached, pull out the old hub assembly and install the new one, ensuring all bolts are torqued to specifications. Finally, reassemble the brake components, wheel, and lower the vehicle.
How do you change the front rotors on a 2004 Chevy tracker
yes
Front or rear?
it is in the very front of the radiator,between the grille,and the radiator,it is an electric motor.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f53e
I own 2003 Tracker 4x4 4 cyl. My crossmember is rusted out and the dealer will replaced- no cost to me. But I have question: if the crossmember is out - will be easy to replace the oil pan and starter ? any saving for me? Mark
yes
Remove the headlight assembly and you will have access to the parking light bulb.
It's a sealed unit with the hub. You have to replace the whole hub assembly.
Unscrew door handles in front first then just pull off door panels carefully unscrew speakers and replace with new.
Pull the complete headlight assembly out to get to the bulbs. You first have to pull the front bumper off, along with the wheel well to get to the headlight assembly.
Here is a link to some good instructions. http://reviews.ebay.com/ebaymotors/Chevy-Silverado-4x4-Front-Wheel-Hub-Bearing-Replacement_W0QQugidZ10000000002536494