answersLogoWhite

0

Hi, If you're talking about the bulb, all you do is turn the locking ring/cap and gently pull the bulb out from the back. Remove the bulb and replace (don't touch the bulb with your fingers) with a new 9004 bulb. When you remove the bulb, be careful not to lose the wave washer if your requires one ( those made in Canada require a wave washer). If your locking cap is just loose and doesn't lock tightly, then you most likely need the wave washer available from your local Suzuki dealer. I tried GM and they said there were none in the country so I went to my Suzuki dealer. Part # 35177-60AB0 about $3.53. If it's the entire headlight assy then start by removing the bulb. The rest of the assy looks as if you need to remove the grill first to get at some screws and be able to remove and reinstall the assy. I've gone out to mine and looked this over. There are some screws on the inside of the engine area, well at least under the hood at the headlight assy. It looks to be a rather straightforward removal and installation. I just would look for prts at a salvage yard (junkyard) or whatever they call it in your area, even auto reclamation area, they all do the same thing. You may have to remove it yourself or they may do it, I've found it varies but I've been able to re-equip my '97 with quite a few things that way. E-Bay is the other place for a complete headlight assy, just try and not pay too much if you go that way. I've also replaced my bulbs (9004) with the Sylvania Ultra and love them, again, just be careful and not touch them. If you get body oil or a fingerprint on a halogen bulb, the bulb gets hotter at the place where you touch it. The light pattern is not correct and the life of the bulb is shortened because it burns hotter at that point and can dramaticly shoten the bulb life. Well, good luck and I hope this helps if you haven't already done all this. Steve H.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you add refridgerant to 1997 Geo Tracker?

How do you add refridgerant to a 1997 Geo Tracker?


Your 1997 geo tracker will not start unless you jump the solenoid with a screwdriver what is wrong?

replace the solenoid ,is shorted.


What kind of coolant does a 1997 geo tracker use?

The 1997 Geo Tracker uses Beck Arnley 252-1501C Blue 50/50 Premix coolant. The Geo Tracker has a coolant capacity of 5.5 quarts.


Where is the starter relay on a 1997 Geo Tracker?

How cha~ge oil tra~smisio~ of a geo tracker 95


Where is fuel pump on a 1997 Geo Tracker?

its in the tank


1997 top selling car model?

GEO Tracker


What rear end will fit 1997 geo tracker 2wd?

No


Is there a block heater frost plug on a 1997 geo tracker If so where is it?

The 1997 Geo Tracker block heater does have a frost plug. The Frost plug will be a few inches below the block heater.


Will a hood from a 1996 Geo Tracker fit a 1997 Geo Tracker?

Yes, a hood from a 1996 Geo Tracker will fit a 1997 Geo Tracker. Both models share the same body design and dimensions, making many parts interchangeable, including the hood. However, it's always a good idea to check for any minor differences in mounting points or hardware.


Is it possible to replace a 1996 Geo Metro Headlight with a 1998 Geo Metro Headlight?

Yes it shoud fit. Geo metros had the same headlights from 1995 - 1999


What number fuse is the headlight on a 1996 Geo Tracker?

The headlight fuse for a 1996 Geo Tracker is typically a 15 amp fuse. You can find it in the fuse box under the dashboard or in the engine compartment. Always refer to the owner's manual for the exact location and specifications for your specific model.


Can you replace a crankshaft in a 1991 Geo Tracker without pulling engine?

No