0
To replace the shift cable on a 2000 Mercury Sable, first, disconnect the negative battery terminal for safety. Then, remove the console cover to access the shift lever and detach the cable from the lever. Next, follow the cable to the transmission, remove the retaining clip, and pull the cable out. Install the new cable by reversing the process, ensuring it's properly secured at both ends before reassembling the console and reconnecting the battery.
What else can I help you with?
How do you replace the gear shift cable on a Ford Taurus - Mercury Sable?
There are 2 excellent write-ups on the procedures for replacing the shifter cable, one for floor shift and column shift each, at the Taurus Car Club site. See Related links below for more information.
How do you remove a shift knob from a Mercury Sable?
2002
Where is the backup light switch located on a 1995 Mercury Sable 3.8?
This is part of the neutral safety / transmission shift location switch / back up light switch. It is mounted on the transmission behind the shift sector shaft. The shift cable will run from the shifter to the transmission and this switch is mounted there on the side of the transmission.
Pontiac sunbird is running but wont shift into drive?
replace the shift cable
What is the cost to replace transmission modulator valve on a 1991 Mercury Grand Marquis?
sorry that's a aod transmission they don't have modulators.the shift is controled by the kickdown cable
How do you install throttle cable and shift cable on your 1984 40 hp mercury outboard?
The throttle cable and shift cable on a 1984 40 HP Mercury outboard engine is installed by raising the access panel and locating the appropriate connectors. Each cable is then attached to the engine to control its speed and gearing.
How do you replace the shift cylinoid in a 97 mercury villager?
Shift solenoids are inside the transmission, and require disassembly of the transmission to replace.
How to replace the shift indicator cable in a 1994 Cadillac Deville?
The cable is part of the shift indicator assy . Must be replaced as a unit
1999 mercury sable 3.0 wont shift out of first gear?
Sounds like you have a bad Vehicle Speed Sensor.
How do you replace automatic gear-shift cable 2000 corolla?
I need to repair the gear shift cable in side a 2000 toyota corolla. How do you get in side the gear shift box to repair the cable end?
How do you change gear shift cable 2000 xlt expedition?
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
What is the best way to replace an MTB shift cable?
To replace an MTB shift cable, follow these steps: Shift to the smallest gear in the rear and front. Loosen the cable anchor bolt and remove the cable. Thread the new cable through the housing and attach it to the derailleur. Pull the cable taut and secure it with the anchor bolt. Test the shifting to ensure it is working properly.
