answersLogoWhite

0

Good question! I'd like to know too. My Haynes manual wasn't very helpful. It said to just remove the two screws at the top of the case and pull the thing straight out. I took the screws out, but the case seems to still be attached at another point. What a mystery! Okay... so Haynes was right. You just have to pull really hard. Nothing broke. :)

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

Why is the theft light blinking on my 2002 Mercury Mountaineer and it will not crank?

had to replace the battery in my 2002 Mercury Mountaineer but now the theft light is blinking, it is cranking up. How can I stop it?


Why does the glove box light stay on in a 2000 Mercury Mountaineer?

Because your switch is bad, replace the light assembly


Where check engine light is located on 1997 Mercury Mountaineer?

On a 1997 Mercury Mountaineer : The " CHECK ENGINE " warning light is just to the left of the battery voltage gauge


How do you replace the tail light bulbs on a 2005 mountaineer?

I have an 02, but it should work the same way. Unscrew the tail light cover from the outside, then pull it off.


How do you replace the mirror light bulb puddle lights in a Explorer - Mountaineer?

To replace the mirror light bulb puddle lights in a Ford Explorer or Mercury Mountaineer, first, ensure the vehicle is turned off and the key is removed. Carefully pry off the light assembly cover using a flathead screwdriver or a trim tool, taking care not to damage the surrounding area. Remove the old bulb by twisting it counterclockwise and insert the new bulb, then reattach the cover. Finally, test the lights to ensure they are functioning correctly.


Why does OD light flashes on and off in your 1997 mountaineer?

od light flashing on 1997 mercury montoneer


How can I reset the service engine soon light on a 2006 Mercury Mountaineer?

To reset the service engine soon light on a 2006 Mercury Mountaineer, you can buy a scan tool. Make sure you note down the numbers before scanning.


What would cause an abs light to come on on a 98 mercury mountaineer?

An ABS fault.


What is the fuse number for a cigarette light on a 2002 mercury mountaineer?

According to the 2002 Mercury Mountaineer Owner Guide : ( fuse # 24 is a 15 amp fuse for the cigarette lighter and OBD II )


How many days can you drive with the check gauge light on in a 1997 mercury mountaineer?

The check " gage " light on in your 1997 Mercury Mountaineer indicates that either your engine oil pressure is LOW , your engine temperature is HIGH or your gas tank is AT OR NEAR EMPTY .


How do you fix the door ajar light on a 2002 mercury mountaineer?

spray your door latches with wd40.


Why does the check engine light blink on your 1998 mercury mountaineer?

An engine misfire has been detected