0
!. open hood 2. drain remaining solvent from radiator 3. Remove radiator 4. remove fan belt 5. remove fan blades 6. remove existing water pump 7. reverse procedure 8. fill radiator 9. run engine, (makeing sure water lines are not airbound, if so, bleed lines by disconnecting one hose) 10, let engine run until you can get heat out of the heater 11. Check for leaks !2. close hood 13. short road test and check for leaks again, check fluid level
What else can I help you with?
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How long should it take to replace a IAC valve in a 1988 Chevy S-10 pickup?
5 to 10 minutes.
Where is the 1988 Chevy engine control module?
In a 1988 Chevy pickup the ECM is located behind the glovebox.
How much did a Chevy pickup cost in 1988?
10,000
How do you remove and replace a heater core in a 1988 Chevy 4x4 pickup?
Take the glove box out. Look in behind. Have fun -- it's not a nice job.
How much does it cost to replace a water pump on a 1988 Chevy 3500 CK?
it depends on who does it.
Does a 1988 Chevy pickup have a fuel pump safety switch?
NO. it does not.
How do you replace starter on 1988 Chevy 1500 pickup?
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
How do you replace the heater core in a 1988 Chevy S10 pickup 4.3 liter?
you need to take apart the lower dash on the passenger side. This is not a fun job.
How do you get your 1988 Chevy pickup to get fire?
you need: fuel compression and spark
Where can you get a vacuum hose routing diagram for a 1988 s10 v6 pickup?
I have a 1988 chevy s10 pickup 2.8. I went to the service department at my local chevy dealership and they printed out 3 diagrams for me for free.
How do you replace a rear seal on the drive shaft of a 1988 Chevy S10 pickup?
The driveshaft unbolts from the diff at the rear. If you haven't found this out maybe its best to take it to a garage.
