0
To replace the water pump on a 2000 Mercury Mountaineer, first disconnect the negative battery terminal and drain the coolant from the radiator. Remove the serpentine belt, then detach any components obstructing access to the water pump, such as the fan or timing cover, if necessary. Unbolt the water pump from the engine block, clean the mating surfaces, and install the new pump with a new gasket. Reassemble all components, refill the cooling system with coolant, and reconnect the battery.
What else can I help you with?
How do you replace the air brakes on a 2000 Mercury Mountaineer?
The Mercury Mountaineer has hydraulic brakes, not air brakes.
Will a transmission on a 2005 mercury mountaineer fit on a 2000 mercury mountaineer?
No,a transmission on a 2005 mercury mountaineer will not fit on a 2000 mercury mountaineer unless you change the oil message on the mountaineer.
Is a 2000 mercury mountaineer unabody?
No , a 2000 Mercury Mountaineer is body on frame
How do you clean carburetor on 2000 mercury mountaineer?
The engine is fuel injected so there is no carburetor on a 2000 Mercury Mountaineer
Why does the glove box light stay on in a 2000 Mercury Mountaineer?
Because your switch is bad, replace the light assembly
Which fuse is for the cigarette lighter in a 2000 Mercury Mountaineer?
Fuse # 17 is a 25 amp fuse for the cigarette lighter in a 2000 Mercury Mountaineer
Firing order for spark plugs on 2000 mercury mountaineer?
firing order for 2000 mercury mountaineer with a 4.0, v-6 engine
How do you set clock on 2000 mountaineer?
'how do I set the clock on a 2001 mercury mountaineer'
Where is the fuel pressure regulator in a 2000 mercury mountaineer v-8?
were is fuel regulater 2000 mountaineer 5.0
How many gallons does the gas tank hold for a 2000 Mercury Mountaineer?
According to the 2000 Mercury Mountaineer Owner Guide : ( the gas tank holds 21.0 U.S. gallons )
Where is the O2 sensor for bank 1 sensor 1 for a 2000 mercury mountaineer?
The oxygen sensor for bank 1 sensor 1 for a 2000 mercury mountaineer is on the cylinder #1 side.
How do you replace the rear windshield wiper in a 2000 mercury mountaineer?
Raise the wiper blade and hold. Pull the release on the bottom of the blade and wiggle it off.
