The Ford Windstar has the most common hook-end wiper arms. See sources and related links below for installation videos. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The 2002 Ford Windstar takes 24" driver side, 20" passenger side and 16" rear replacement windshield wiper blades.
The 1996 Ford Windstar takes 24" drivers side, 20" passenger side and 16" rear replacement windshield wiper blades.
You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.
Heat cut the windshield out, just make sure not to damage the brake lights, and the windshield wiper, fit the new glass to the back, and weld it on the inside after removing the fabrication, put the fabrication back on, make sure the brake lights and windshield wiper work, and if they do, you're good, if they don't, visit an inspection shop, they'll hook ya up.
To replace the windshield wiper linkage bushings on a 2002 Ford Ranger, first, remove the wiper arms by loosening the nuts and lifting them off the posts. Next, remove the plastic cover from the base of the windshield to access the linkage. Disconnect the wiper linkage from the motor and the windshield frame, then replace the worn bushings with new ones. Reassemble everything in reverse order, ensuring all connections are secure before testing the wipers.
Just in case this question is missing the word wiper or washer fluid...See "Related Questions" below for that answer...
read owners manual for info
No separate container to fill for the rear. The front washer solvent reservoir serves both front and rear sprayers.
When the windshield wiper on a 2000 Ford Ranger comes on by itself this can signal a damaged windshield wiper switch. Changing these switches out often corrects this problem.
Take it to a Ford Dealer.
Check the Owners Manual (see below), or take your van to a place that installs them for free. Have the person show you how to do while they install your new ones - you'll be ready for the next time.
To replace the wiper blades on a 2007 Ford 500, first lift the wiper arms away from the windshield. Press the small tab on the wiper blade connector to release the old blade, then slide it off the arm. Align the new wiper blade with the arm and push it on until you hear a click. Finally, lower the wiper arm back onto the windshield and repeat for the other side.