Remove the serpentine belt by going clockwise with a 3/8 breaker bar on the belt tentioner UNDER the truck (I had to use my 1/2" breaker bar with a 3/8" adapter). Have someone remove the belt off the alternator as you remove tension under the truck (jack the truck up just a bit to fit) there is a square 3/8" for a socket ratchet to fit into on the tentioner underneath. Then remove the 2 - 13mm bolts on the alternator on top of the truck (under the hood). They are long bolts and rather tight, I loosened them with a breaker bar and then air ratcheted them out the rest of the way. Even with my cheap $20 air ratchet and $40 compressor, it does the job because there is not much room in there. Now pry the alternator loose with a BIG screwdriver, side by side until it's flopping around a bit. Then remove the 1/2" nut off the alternator wire and remove the wire. Now the fun part, getting it out of the engine compartment. It comes out BACK first, take the bolt to the wire out first and the entire black rear towards you (barely enough room). The pulley will be facing towards the engine and wiggle back and forth until it slides out. Good luck on the arm cuts! I didn't put my new one back in yet but I am sure it will be fun. Tom.
you need a new alternator
How do I replace the heater core in a Chevy express 1500
i need a diagram of how to inslall the belt on my truck
take your vehicle to a licensed mechanic
The common consensus is 1200 to 1500.
Hi You cant replace the selenoid you have to buy a new starter. No one sells selenoids for these starters.
puting your finger in the motor
Hi You cant replace the selenoid you have to buy a new starter. No one sells selenoids for these starters.
If you suspect it is clogged just replace it, then you will know if that was your problem.
need to fix my express van .
parts needed for a tuneup on 2004 chevy express 3500 van
Remove the belt from your 1994 Chevy Astro Van 4.3 liter engine alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.