You just ask a redneck how!!
The transmission lines on a 2000 GMC Jimmy 4x4 are replaced by disconnecting the lines at the radiator and then the side of the transmission. They are then removed from the bottom of the vehicle and new lines put in place.
no it wont hurt the jimmy
automatic
If it is 4x4, you have to replace the whole hub
NO
2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3
I believe it is on the engine valve cover - drivers side
.15mm or .006 inches cold.
what kind of transmission s in my 97 gmc jimmy 4x4?
How do you go about replacing the pitman arm on a 2000 Silverado?
the freeze plugs on the side of the motor could be done.
To replace the clutch on a 2000 GMC Jimmy 4x4 air conditioner, first, disconnect the battery and remove the serpentine belt. Next, unbolt the compressor from its mounting and disconnect the electrical connector from the clutch. Use a puller tool to carefully remove the clutch from the compressor shaft, then install the new clutch by reversing the removal process, ensuring proper alignment with the compressor. Finally, reassemble all components, reconnect the battery, and check for proper operation.