answersLogoWhite

0

take the steering wheel off and take the ignition lead off and then you buy a new ignition with new key or vis versa

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace lost ignition keys to a 1984 Monte Carlo?

you will have to replace the complete ignition switch with a new one.


How to remove ignition switch 1984 Chevy Caprice?

How to remove ignition switch


How do you replace a 1984 Chrysler Lebaron ignition switch?

To replace the ignition switch on a 1984 Chrysler LeBaron, first disconnect the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it apart. Locate the ignition switch, disconnect the wiring harness, and remove the switch from the column. Install the new ignition switch by reversing the steps, ensuring all connections are secure before reassembling the steering column and reconnecting the battery.


1984 corvette you need to replace the door lock switch how do you get to the switch?

== ==


Where is the Headlight circuit breaker in a 1984 Caprice?

It is built into the switch and is not serviceable. You will have to replace the switch assembly.


What causes the ignition switch to rotate without powering up the ignition system and not starting on a 1984 Chevrolet pickup with tilt steering?

If your battery is fully charged and the connections are clean and tight, the problem is probably that the contacts in the switch are corroded or worn, meaning your ignition switch will have to be replaced.


Where is the ignition switch located on a 1984 Dodge pickup truck?

The ignition switch on a 1984 Dodge pickup truck is typically located on the steering column. To access it, you may need to remove the lower steering column cover. The switch is usually mounted near the ignition lock cylinder, where the key is inserted. Always refer to a service manual for specific details related to your model.


Why is there no power to your fuel pump fuse 1984 Chevy Celebrity?

I would expect that the power for the fuel pump would be supplied through the ignition switch so I would start there, that is check the ignition switch.


What do you do when you turn the ignition key on to start on a 1984 Mercury Capri 5.0 but it does not stay running when the ignition is brought back to the run position?

replace the balist resister replace the balist resister


Why wont your 1984 dodge startengine turns overhas fuel at carb does not have ignition spark?

== answer== Could be a bad ignition control module or coil,points if equiped,cap,or rotor,bad ignition switch.


Is emergency brake release lever on 1984 elderado cadillac?

inside light on dash will not go out when the ignition switch is off


How do you replace the timing belt on a 1984 Ford Ranger 3.2 liter?

NOT AN EASY JOB get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM. It has pictures .