0
To replace the ball joints on a 1988 Chevy Blazer 4WD, first, safely lift the vehicle and remove the front wheels. Disconnect the brake caliper and rotor, then remove the lower control arm and any necessary components to access the ball joint. Using a ball joint press, remove the old ball joint and install the new one, ensuring it's properly seated. Reassemble the components in reverse order, and don't forget to check the alignment after completing the job.
What else can I help you with?
IS A 1987 CHEVY TRUCK DOOR INTERCHANGEABLE WITH A 1988 K5 BLAZER?
Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988
Will a 2.8 engine from a 1988 Chevy beretta fit a 1989 Chevy blazer?
Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...
How do you adjust the choke on a 1988 Chevy s 10 blazer?
There is no choke to adjust.
How do you set timing on a 1988 Chevy blazer s10 v6?
I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.
Where can you find a wiring diagram of the ignition system on a 1988 Chevy S10 Blazer?
autozone.com
Would wheels from a 1988 Chevy caprice fit on a 1997 Chevy blazer?
we are trying to find regular factory wheels that fit the lug pattern off of a 1997 Chevy blazer s-10 2 wheel drive
What are the speaker sizes in a 1988 Chevy Blazer s10?
The 1988 Chevrolet Blazer front speakers measure three inches by four inches. The rear speakers measure four inches by five inches.
Where is the solenoid starter on a 1988 Chevy s10 blazer?
It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.
Window on 88 Chevy blazer will not go down?
A blown fuse could be the reason the window will not go down on your 1988 Chevy Blazer. Another possibility is that the switch is worn out or has a loose, broken, or corroded wire.
Will the transmission from a 1988 Chevy s10 blazer with a 2.8 liter engine fit in a 1989 Chevy silverado with a 5.7 liter engine and a 700r4 transmission?
no
Where is the ignition switch module located on the 1988 Cherokee limited?
module locatedwhere is the module on a 9 Chevy blazer
Where is the mass air flow sensor on a 1988 Chevy Blazer S-10 4.3?
It doesn't have a MAF sensor.
