answersLogoWhite

0

Disconnect all the hoses going to the engine, under neath the car unbolt the bolts from the bell housing from the transmission, disconnect all the wires that goes to the engine, unbolt the engine from their mounts. Attach the engine jack to the intake manifolds bolts then jack up the engine and take it out. I hoped this helped

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Why does the front blower not work but the back does town and country?

how do you replace a resister on a front heater blower on a 2006 chrysler town and country touring with a 3.8 motor


Diagram for Chrysler Pacifica blower motor replacement?

A diagram outlining how to replace a blower motor in a Chrysler Pacifica can be obtained from most auto-parts stores. Many Chrysler dealerships will also make the diagram available.


Where is the blower motor on a 2001 Chrysler Town and Country?

The blower motor is inside the bottom of the hvac housing, under the dash on the passenger side.


What causes the blower motor to work on high only in a 2001 Chrysler Town and Country?

Usually the blower motor resister has gone bad.


How do you replace a 99 Town and Country blower motor?

To replace the blower motor in a 1999 Chrysler Town and Country, first disconnect the battery to ensure safety. Remove the dashboard panel or glove box to access the blower motor, typically located under the passenger side dashboard. Disconnect the wiring harness and remove the mounting screws to free the old motor. Install the new blower motor by reversing the removal process, reconnecting the wiring, and reassembling the dashboard components.


How do you replace the heater blower motor in a 2005 Chrysler Pacifica?

A heater blower in a 2005 Chrysler Pacifica is a complicated process. To get this [project done, you will have to go to a mechanic and have it done.


Why does the heat not work in a 2004 Chrysler Pacifica?

replace heater relay and or heater blower motor


How do you fix Chrysler town and country blower motor not shutting off?

On an auto temp system the blower motor resistor has failed and needs replaced.


Where is the blower motor resistor on a 1997 Chrysler Town and Country?

The blower motor resistor is over the passenger side strut tower, under the hood.


If the Blower motor doesnt work and switch motor relay and fuse are good what could be the problem on an 2005 chrysler town and country?

Resistor or blower motor power module.


How do you replace blower motor on 1999 Chrysler LHS?

To replace the blower motor on a 1999 Chrysler LHS, first disconnect the negative battery cable for safety. Remove the passenger side lower dash panel and locate the blower motor, which is usually situated under the glove compartment. Disconnect the wiring harness and unscrew the blower motor from its housing. Install the new blower motor by reversing the steps, ensuring all connections are secure before reassembling the dash panel.


Where is the blower motor resistor on a 2005 Chrysler Town and Country Touring?

It is behind the glove box.