remove tire, remove brake callipar, remove hub bearing bolts (3). remoce drive axle nut 1-5/16 remove lower control arm, pop out drive axle.
yes it does!! the front axles on your car a called cv axels, the joint on the axel is called a cv joint!!
cv axels if it does it when you are turning
Sounds like a bad CV joint. On most cars, it is often more economical to replace the complete axle shaft on that side that has a bad cv joint. Hope this helps. Good-luck!
You have a bad CV joint in one of the front axels, and you did not say what side the noise was coming from. If you are smart you will replace the whole axel shaft. and you will get two new CV joints with it as a unit.
It could be a CV joint going bad. If you look under the front of the car there are two axels, one on each side. On the ends of the axels there are rubber boots, if they get torn they let in dirt and ruin the CV joint.
if it is when you turn a corner, it is probably your outer cv joint, if it is when you are driving in a straight line it is probably your inner cv joint. axels
It is either your axels or your cv joints. Not an important repair but it is annoying
The average cost to replace CV joints is approximately $300. It is more inexpensive and less time consuming to replace both CV joints.
your cv axels and or power steering pump has to much load on your motor change the pump. cv joints scrub speed in corners but will not make car stall
how do you replace a CV joint on a 1992 Chevy pickup?
how do you replace the drivers side drive shaft and cv joint?
It is not cost-effective to attempt to replace just the CV joints. Rebuilt CV shafts are available for as little as $60.