0
To replace the fuel pump on a 1999 Mercury Villager Sport, first, relieve the fuel system pressure by removing the fuel pump fuse and running the engine until it stalls. Then, disconnect the battery and drain the fuel tank. Remove the tank by unbolting it from its supports and disconnecting the fuel lines and electrical connectors. Finally, access the fuel pump by removing the retaining ring from the top of the tank, replace the pump, and reassemble everything in reverse order.
What else can I help you with?
How do you Replace crankshaft on 1999 mercury villager?
You don't, you replace or rebuild the engine.
What are the rod bearing torque specs for a 1999 Mercury Villager with a 3.3L engine?
2000 Mercury sport villager with 3.3liter what does the rod caps torque at.
How do you replace oxygen sensor on a 1999 mercury villager sport?
Unplug the sensor and unscrew it from the exhaust pipe. You'll probably need a special socket to do it without damaging the wires.
Where is the directional signal flasher located on a 1999 mercury villager sport?
Under the dash near the fusebox.
Where thermostat 1999 villager?
How do you change the thermostat in 1999 Mercury Villager
Will a 2001 mercury villager 3.3 fit in a 1999 mercury villager?
Yes.
How much to replace gas tank in 1999 mercury villager?
Probably around $200 for the tank, and $200 for labor.
How many gallons does the gas tank on a 1999 Mercury Villager Hold?
According to the 1999 Mercury Villager Owner Guide : ( 20.0 US. gallons )
How do you replace rear brakes on a 1999 mercury villager?
This is as complex procedure. I suggest you buy a repair manual if it is not obvious to you, and you don't have experience.
Where is the crankshaft on a 1999 mercury villager 3.3?
In the engine.
What refrigerant is used in a 1999 Mercury Villager?
134-A
Can you put headers on a 1999 mercury villager?
No, no room.
