remove the plastic cover where the light is, then remove the 4 screws that hold the the thin metal frame that holds it in place. pull the bulb out, unplug it and then reverse the process
There are 2 long clips behind the headlight housing, remove them and the housing will lift out. Then just unscrew the bulb and replace with a new bulb.
H11
To replace the headlamp bulb on a 2008 Kia Amanti, first, open the hood and locate the back of the headlamp assembly. Disconnect the electrical connector from the bulb and remove the retaining clip or twist the bulb socket counterclockwise to release it. Replace the old bulb with a new one, ensuring not to touch the glass with your fingers, and then reassemble by reversing the steps. Finally, test the headlamp to ensure it is functioning properly.
with your hands ?
ask someone else to do it
To replace the headlamp on a Citroën Xantia, start by opening the hood and locating the headlamp assembly. Remove the screws or clips securing the headlamp, then carefully pull the assembly out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, and secure the headlamp assembly back in place before testing the new bulb.
To replace a headlamp bulb on a 2007 Nissan Murano, first, turn off the vehicle and open the hood. Locate the back of the headlamp assembly, then remove the electrical connector by pulling it straight off. Twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one, taking care not to touch the glass. Reinsert the bulb socket, reconnect the electrical connector, and test the headlamp before closing the hood.
Open hood. On the inside (toward the center of the car) of each headlamp is a plastic clamp fixing one side of the headlamp. On the ouside from the top unscrew the bolt holding the other side of the headlamp assembly. Lift the lamp assembly out of the car and remove (pull off)the connector to the bulb. Next peal the rubber boot from the back of the headlamp assembly. This will expose a spring clip that holds the halogin bulb in the headlamp assembly. Remove bub and replace with a new bulb being carefull to only touch the bulb by its metal base connector. Do not touch the glass areas.
1/4 turn to release the old bulb.
very carefully very carefully
Carefully! there very expensive.
Don't look on this site anyway