To replace the ignition cylinder in a 1993 Pontiac Sunbird V6, start by disconnecting the negative battery cable to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it off. Insert the key into the ignition and turn it to the "Run" position, then locate and depress the pin or release tab on the ignition cylinder to pull it out. Finally, insert the new ignition cylinder, reassemble the steering column cover, and reconnect the battery.
they did make a sunbird in 1998!
what is the color order of the wires to a Pontiac Sunbird ignition module
I believe that the fuel pump for the 94 Pontiac sunbird is in the gas tank.
To replace the ignition on a 1993 Pontiac Sunbird, first disconnect the negative battery cable to ensure safety. Remove the steering column covers to access the ignition switch, then detach the wiring harness and unscrew the ignition switch from the column. Install the new ignition switch by reversing the process, securing it in place, reconnecting the wiring harness, and replacing the steering column covers. Finally, reconnect the battery and test the ignition to ensure it works properly.
It dep[ends on exctly which engine you have as to how difficult it is, Get a manual you your car and do the job correctly .
Yes. It's the new transformer.
In the tank
4 quarts
I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!
replace the shift cable
1 3 4 2
for a 4 cylinder it is 1-3-4-2