http://www.corvetteradios.com/ sells the bulbs for the GM k1500 radios. They have a diagram showing how to solder them to the circuit board on their site.
you got to replace to light bulbs
To replace the daytime running light on a 2004 Suburban, you will have to first remove the two metal pins that can be found on top of the headlight. The headlight assembly can be removed next. Pull out the plugs that are connected to the headlight assembly. Replace the bulbs and then reconnect the assembly.
You have to remove the instrument cluster to service the light bulbs.
Remove the screws that hold the covers in place. Replace bulbs!
if it is an LED unit you cant you have to change the assembly as a unit
The bulbs unscrew from the back of the light assy. sometimes you have to remove it to get to the back.
no
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban
Open the rear hatch and you will see the retaining screws inside the door frame.You can then drop the light out to get access to the bulbs. If no bulbs are bad then you may have a bad circuit board.
If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.
The # is 1157 bulbs.
If you put the tail gate down and look at the inside of the bed whare the tail light is mounted you will see 2 small screews. Remove the screews and take the light out and you will see the bulbs in the back of the light.