0
What else can I help you with?
How do you replace rear differential pinion bearing?
trying to replace rear pinion bearings 1993 ford aerostar, 7.5 rear differential...slinger washer on drive shaft side is stuck, cant get pinion shaft out, all differential parts have been removed...any suggestions?
What is the source of a grinding noise coming from the rear of a 2001 Ford Mustang GT?
axle bearing or brakes or pinion bearing
How do you change a rear pinion bearing on a 1999 Dodge 1500 RAM 4X4?
remove rear drive shaft from vehicle.remove large nut ( pinion nut) at front of diff, which is generally hidden when driveshaft is in place.with a bearing puller remove pinion bearing, replace with new one. install new pinion seal. reinstall pinion cover and pinion nut. tighten to specified torgue.reinstall driveshaft check diff oil for proper amount
What is the preload on the pinion bearing and the backlash on the crownwheel and pinion inside the rear differential of an English 1970 ford escort?
If this helps the sailsbury axle of a cortina details are crownwheel and pinion backlash 0.004-0.008" pinion bearing preload 0.001-0.003" collapsible spacer length 0.453-0.461".
How do you replace the rear wheel bearings on a Ford Courier?
How do I put a wheel bearing on with out a wheel bearing press
How do you replace a rear wheel bearing on a dodge ram?
In order to replace the rear wheel bearing you will need to find the axle shaft bearings and remove them. They are located at the center of the housing where the ring and pinion gears and at the axle end near the wheel mounting position.
Why is 8.8 ford pinion yolk loose on rear axle?
It's wore out, so now it loose and the bearing needs to be replaced O
How do you replace a rear tire bearing?
rear ryhits bearing
How do you replace a wheel bearing on a 1988 ford f-150?
Front or rear?? 4x4 or 4x2??
What is the preload on the pinion bearing and the backlash on the crownwheel and pinion inside the rear differential of a 1997 ford explorer 4 wheel drive?
The shim between the inner bearing and the pinion is critical and if it's lost you need special tools to set the pinion depth. replace the bearings and seal with an new crush sleeve thighten the pinion nut until the sleeve crushes and you can't move the pinion up and down. Then very slowly tighten the pinion nut checking the rotational torque. You will need an inch pound torque wrench, when the preload is correct it should take between 20-25 inch pounds of torque to rotate the pinion. If you get it too tight you need to replace the crush sleeve and start over. Proper bearing preload and gear mesh are critical.
How can you take out the play in your driveshaft on the rear end side of a 1997 ford ranger super cab 4.0 5 speed?
if the play is in driveshaft, replace u joints. if the play is actually in the diff, remove driveshaft and tighten pinion bearing.
How do you change rear pinion bearing on a 2004 dodge 1500 ram 4x4?
1. remove rear drive shaft.2.remove diff.cover.3.remove both axles.4.remove carrier case assy.5.remove drive shaft yoke.6.tap pinion gear out of housing with (brass hammer).7 remove pinion seal and front pinion bearing.8.rear pinion bearing well need pressed off & on the pinion gear.9.you need to use a punch drive the bearing race from housing both.
