How do you replace signal light bulb 1988 Chrysler new yorker?

Answer 1

Rear Signals/Tail Lamps:

You need a #2 Phillips driver.

1. First, raise the trunk lid.

2. On the outside of the car, there is a small piece of metal trim at the bottom of the tail lamp assembly. The screw that holds this piece of trim onto the car faces sideways, which is why you need to raise the trunk lid to get to it. Remove that screw, and with it, the piece of metal trim.

3. Then, there are two additional screws that need removed, both at the bottom of the assembly, one facing the rear of the car, one facing to the outside, to the left or the right. Remove these and then you can tilt out the assembly from the bottom.

4. Twist the socket counterclockwise and ease it out of the assembly WITH the foam washer.

5. The lamps pull out of the socket.

6. Reverse everything and you're good to go.

Front Signals

If they are the ones that face completely frontwards, under the head lamps, you need a T15 driver. If they are the sideways ones, you just reach up under the car, behind the fender to get at the sockets.

The ones that face sideways are the twist out socket types.

The frontward facing ones are self-explanatory: remove the T-15 screws and get on with your life.